Page 105 - Demo

PROLOK INSTALLATIONJULY 2025Determine which flashings need to be installed prior to roofing panels (Eave, Valley & Prow). 1. Install eave flashing with a panhead screw or roofing nail.2. Place sealer tape(Prolok) or small closures(Other Profiles) below the eave fasteners.3. Align the nail flange edge of the first panel with the gable end chalk line. Allow the roof panel to overhang the eave fascia minimum 1%u201d. The panel must be 1 1/2%u201d down from the ridge. Typical sheet length is eave to ridge. Panel is slid down from the ridge and this is now the overhang.4. After the roof panel is properly aligned, screw down the panel in the nail flange slots.Make sure not to over tighten the screw. The gable trim is now ready to be installed. If gable trims are not being installed right away,place a few screws along the female edge to stop the sheet from being blown around in anywind.5. Snap the second panel at the seam. Work the seam together from the eave to the ridge. Do not work the seam from the middle to each end.6. Fasten down the panel by screwing the nail flange through the slots. If the slots are notlocated on the sheeting, screw through theflange using the slots as a guide.7. Continue installing sheets across the roof.